Asus RS320Q-E7/RS12 Manual do Utilizador descarregar pdf (Página 97)

6-3ASUS RS320Q-E7/RS12

6.1.3 Setting the RAID item in BIOS

You must set the RAID item in the BIOS Setup before you can create a RAID set from SATA

hard disk drives attached to the SATA connectors supported by

Intel® C602 chipset. To do this:

1. Enter the BIOS Setup during POST.

2. Go to the

AdvancedMenu>PCHSATAConguration

, then press <Enter>.

3. Set

SATA Mode

to [RAID Mode]

4. Press <F10> to save your changes and exit the BIOS Setup.

Refer to Chapter 4 for details on entering and navigating through the BIOS Setup.

6.1.4 RAIDcongurationutilities

Depending on the RAID connectors that you use, you can create a RAID set using the utilities

embedded in each RAID controller. For example, use the

LSI Logic Embedded SATA RAID

Setup Utility

or the

Intel® Rapid Storage Technology

if you installed Serial ATA hard disk

drives on the Serial ATA connectors supported by the Intel® C602 chipset.

Refer to the succeeding section for details on how to use the RAID conguration utility.

6.1.2 Installing hard disk drives

The motherboard supports Serial ATA for RAID set conguration. For optimal performance,

install identical drives of the same model and capacity when creating a disk array.

To install the SATA hard disks for RAID conguration:

1. Install the SATA hard disks into the drive bays following the instructions in the system

user guide.

2. Connect a SATA signal cable to the signal connector at the back of each drive and to

the SATA connector on the motherboard.

3. Connect a SATA power cable to the power connector on each drive.

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 157 158

Sem comentários

Asus RS320Q-E7/RS12 Manual do Utilizador Página 97