Asus RS100-PI2 Guia do Utilizador descarregar pdf (Página 54)

Chapter 4: Motherboard information4-8

7. Chassis intrusion connector (2-pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch.

Connect one end of the chassis intrusion sensor or switch cable to this

connector. The chassis intrusion sensor or switch sends a high-level signal to

this connector when a chassis component is removed or replaced. The signal

is then generated as a chassis intrusion event.

By default , the pin labeled “Chassis Signal” and “Ground” are shorted with

a jumper cap. Remove the jumper caps only when you intend to use the

chassis intrusion detection feature.

8. MErmwareforcerecoverysetting(3-pinME_RECOVERY1)

This jumper allows you to quickly recover the Intel Management Engine (ME)

rmware when it becomes corrupted.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 129 130

Sem comentários

Asus RS100-PI2 Guia do Utilizador Página 54