Asus P9D-C/4L e8581 Manual do Utilizador descarregar pdf (Página 4)

LSI Software RAID Conguration Utility

II. Using the LSI Software RAID Conguration Utility

The LSI Software RAID Conguration Utility allows you to create RAID 0, RAID 1, or RAID

10 set(s) from SATA hard disk drives connected to the SATA connectors supported by the

motherboard.

B. Setting Jumpers

You must set the jumper settings of your motherboard to activate the

LSI Software RAID

Conguration Utility.

To set the jumper settings

set the 3-pin RAID_SEL1 jumper to pins 1-2.

1. Before you start

Before you proceed, ensure that you have installed the Serial ATA hard disk drives, set the

correct jumper settings of the motherboard, and have set the correct SATA mode in the BIOS

setup. You can refer to following sections for the instructions in

Installing hard disk drives

Setting Jumpers

, and

Setting the RAID mode in BIOS

A. Installing hard disk drives

The motherboard supports Serial ATA for RAID set conguration. For optimal performance,

install identical drives of the same model and capacity when creating a disk array.

To install the SATA hard disks for RAID conguration:

1. Install the SATA hard disks into the drive bays following the instructions in the system

user guide.

2. Connect a SATA signal cable to the signal connector at the back of each drive and to the

SATA connector on the motherboard.

3. Connect a SATA power cable to the power connector on each drive.

LSI

The motherboard illustration is for reference only. Visit www.asus.com for the complete list

of supported motherboards,

1 2 3 4 5 6 7 8 9 ... 41 42

Sem comentários

Asus P9D-C/4L e8581 Manual do Utilizador Página 4