Asus P9D-C/4L e8581 Manual do Utilizador descarregar pdf (Página 5)

C. Setting the RAID mode in BIOS

You must set the RAID mode in the BIOS Setup to be able to launch the RAID utilities before

you can create a RAID set from the SATA hard disk drives attached to the SATA connectors

supported by Intel

C22x chipset.

To do this:

1. Enter the BIOS Setup during POST.

2. Go to the Advanced

Menu > SATA Conguration, then press <Enter>.

3. Set SATA Mode

to [RAID].

4. Press <F10> to save your changes and exit the BIOS Setup.

• The LSI Software RAID Conguration Utility automatically congures to RAID 1 when

the SATA to RAID Mode is enabled.

• The RAID setup screens shown in this section are for reference only and may not

exactly match the items on your screen due to the controller version difference.

• When you create RAID sets with the LSI Software RAID Conguration Utility , the boot

priority of the SATA optical drive has to be manually adjusted. Otherwise, the system

will not boot from the connected SATA ODD.

2. Launching the LSI Software RAID Conguration Utility

To launch the LSI Software RAID Conguration Utility:

1. Turn on the system.

2. During POST, the LSI Software RAID Conguration Utility automatically detects

the installed SATA hard disk drives and displays any existing RAID set(s). Press

<Ctrl>+<M> to enter the utility.

LSI MegaRAID Software RAID BIOS Version A.11 02090932R

LSI SATA RAID Found at PCI Bus No:00 Dev No:1F

Device present at Port 0 ST3160812AS 152114MB

Device present at Port 1 ST3160812AS 152114MB

Device present at Port 2 ST3160812AS 152114MB

Device present at Port 3 ST3160812AS 152114MB

Press Ctrl-M or Enter to run LSI Software RAID Setup Utility.

1 2 3 4 5 6 7 8 9 10 ... 41 42

Sem comentários

Asus P9D-C/4L e8581 Manual do Utilizador Página 5